Home > Windows Xp > Please Help.Windows XP SP3 Setup Hangs/freezes At 34/35 Minutes

Please Help.Windows XP SP3 Setup Hangs/freezes At 34/35 Minutes


Followed this to the letter and bingo - fully functional XP Pro SP2. I was about to throw the computer out the window until I read this. Generic Polar Bear 558,553 views 41:08 windows vista / xp stuck on welcome screen fix - Duration: 3:52. And yes.. this contact form

I went into setupapi.log and found the last few lines to contain a inf file that reads as follows…C:\WINDOWS\inf\oem11.inf the next line after that starts with "Driver not trusted" , so of Justice and Dept. If you are using RAID, did you try it without raid?Click to expand... I am using a SP1 CD which has worked on my other computers. http://www.techspot.com/community/topics/please-help-windows-xp-sp3-setup-hangs-freezes-at-34-35-minutes.151900/

Windows Xp Freezes During Installation

kate Says: January 9, 2007 at 6:01 pm just gone into the c drive and doing it that way… akby Says: January 9, 2007 at 10:09 pm Excellent advice, deleted machine.inf Yesterday I tried the new hard disk, and surprisingly the same problem happened. Change back to AGP and get the message again. Thanks… […] Comments are closed. « Woes Resolved Frameworks and the DesignPattern » Create a free website or blog at WordPress.com.

  1. New Posts Official AMD Ryzen Benchmarks, Reviews, Prices, and Discussion Latest: bjt2, Feb 22, 2017 at 3:54 AM CPUs and Overclocking ++ ATOT official NEF thread part IV ++ Latest: EliteRetard,
  2. Now the installation goes as far as 18 mins left but freezes on "registering components" part.
  3. No copies.

I'm attempting to install XP Pro but it hangs during the "Installing Devices" phase at "setup will complete in approximately 33 minutes). inf If that is of any help. I had been struggling with the problem for 3 days until I found your post. Thanks again for helping Aug 17, 2010 #3 (You must log in or sign up to reply here.) Show Ignored Content Similar Topics Windows XP Home repair install hangs at

When it gets to the spot where it's hanging, press the VM Stop button, answer yes. Windows Xp Installation Stuck At Installing Devices stom said: The reinstall/repair is due to a rpoblem i do not knwo how to fix - windows stopping after entering my user name, and going no further. You can change this preference below. Error 0xe0000228: There are no compatible drivers for this device. #W157 Default installer failed.

Life Saver Fix Netpsa.inf Errors - Windows XP, Vista, 7 & 8 Sunday, September 21, 2014 […] XP Installation – The 34 minute hiccup | Techtracer – You want to install I restarted like 4 times and it continues to hang in the same place. I had tried everything. Oasis Says: October 14, 2006 at 1:57 pm Using this method now..

Windows Xp Installation Stuck At Installing Devices

Do you have a good powersupply? #24 psiu, Jun 22, 2004 nanaki333 Diamond Member Joined: Sep 14, 2002 Messages: 3,772 Likes Received: 13 assume everything is broken. check it out Same problem. ***UPDATE: Have successfully installed win98 on the computer. Windows Xp Freezes During Installation Sorry for the stupid question… Thanks joe nitinpai Says: October 29, 2006 at 1:34 pm Hi Joe K, Just do a "dir" in the command prompt.. Windows Xp Setup Stuck says that a few times and also says "processing of call to class installer failed.

The last line in the file is: class installer failed: an exisiting device was found that is a duplicate of of the device being manually installed. http://uberbandwidth.com/windows-xp/please-help-windows-xp-restarts-when.php Regards, Scott sbalthazor, Jun 18, 2007 #2 nycruza Messages: 224 spiderdan said: I have a brand new 15" MBP (Santa Rosa; NVIDIA 8600M GT graphics controller; etc.). This will make the prompt C:\Windows> Then go to the inf folder C:\Windows>cd inf which will make the prompt C:\Windows\inf> and finally delete the respective inf.. Christina Says: December 22, 2006 at 1:36 am Mine hangs at 33 minutes - apparently that is past hardware detection. Windows Xp Installation Stops At 34 Minutes

Thank you and more. says that a few times and also says "processing of call to class installer failed. I deleted it and it sent my comp into the BSOD reset loop. navigate here Sponsored Links Latest Articles How to migrate preferences of one Eclipse workspace to another?

I noticed a couple of the issues the setup is having with installation is with things labeled VIA whereas my mobo is now using an Nvida Nforce chipset… any other ideas Login now. Aaron Padoshek, May 10, 2009 #12 DaTa Messages: 194 Hello, Please, use http://kb.parallels.com/en/6421 DaTa, Jun 12, 2009 #13 AnttiK Messages: 2 Now I do not know whether this'll help anyone

Thanks All, still searching for a solution, Robert Adrian Says: January 4, 2007 at 5:14 pm Mine has this issue but after following the instructions and deleating volume.inf i still have

anywayz ur GR8!!! Hope this is helpful. YMMV #18 GregANDTCH, Jun 22, 2004 huesmann Diamond Member Joined: Dec 7, 1999 Messages: 8,614 Likes Received: 0 Try installing with your case open and good air flowing. it went from 39 minutes down to 35 minutes and froze on the installing devices part.

Related Resources xp install freezes after 34 minutes Windows xp sp2 installation hangs upon reaching 34 minutes remaining Blue screen at 35 minutes to go in Windows XP installation New XP hope this leads to better ends for ya. #7 Zanix, Jun 21, 2004 Gokuto Junior Member Joined: Jun 21, 2004 Messages: 22 Likes Received: 1 Originally posted by: Zanix Just However, after removing the CD of XP Home OEM SP0 and then putting it back it went through the 33 min point. his comment is here Dave Says: December 20, 2006 at 8:07 pm Same prob as you Andy, i need help too!

Kidding. So I would suggest to take the backup of your data on some other machine from your hard drive and do a fresh installation on your new system configuration. nookeen, Nov 3, 2008 #10 Michel Houde Messages: 1 Hangs at 33 minutes georgewwwbush is right. On trying a third time, it got stuck at 68%, also at "expanding windows files".

AnttiK, Feb 11, 2010 #14 LaneR Messages: 2 INF fix doesn't quite work So I tried the above mentioned fix of opening up the setupapi.log then finding the "inf file" however then i can get to the screen where it asks you to go to safe mode or start windows normally, but if i choose start windows normally it loads and restarts Kevin Says: January 8, 2007 at 6:01 am Michael, This was similar to the situation I was in prior to repairing my Windows install. and update, i've tried swapping out my ram sticks but no configuration is getting me anywhere. #12 Gokuto, Jun 21, 2004 Gokuto Junior Member Joined: Jun 21, 2004 Messages: 22

Ask a question and give support. I don't know.. So I guess you would have to reluctantly go to some other place which can offer some expert advice. I'd say it was heat, but it would be at different times as the installations progressed.

This may tell you the device class instead of the specific device.If the Setup log files indicate that a hardware device or a driver may be causing the problem, verify that Getting deseperate, any ideas? If its a bad sector problem then your hard drive ougt to be replaced. it was flpydisk.inf and thanks to Nitinpai's original solution, I was able to deal with that.

stomJun 21, 2006, 8:13 AM Well its Windows x64, but that shouldn't make much of a difference...